porducts list
- Other [19]
contact datails
Shenzhen Goldenshield Technology Co.,limited.
MR William Bei
18/A-I,Block B,Fortune Plaza,No.7060 ShenNan Road,Shenzhen,Guangdong Province,CN.
86-755-86314757
MR William Bei
18/A-I,Block B,Fortune Plaza,No.7060 ShenNan Road,Shenzhen,Guangdong Province,CN.
86-755-86314757
| Features: 1. Adopt three bands, GSM 900/1800/1900MHz, alarm remotely without the limit of distance. 2. 300,000 pixels Digital camera, waterproof and night vision function, IR light compensation, hint function for camera fault. 3. Support GSM/CDMA, remotely control the alarm host to arm/ disarm/listen-in/photo-taking by SMS. 4. Support image motion detecting function which can capture thief ‘s photo and send to 5 user cell phone or 2 e-mail box, or stored into the SD card for evidence. 5. The picture to be transmitted adjustable: VGA (640x480), CIF (320x240), QCIF (160x128). 6. Support Max.2G SD card, can store 28,800 pieces of pictures. 7. Remotely arm/disarm/listen-in/photo-taking/send MMS by remote controller or SMS. 8. Support two-way intercom, can turn on the siren remotely, and speak to the alarm spot. 9. Listen-in function: Can clearly hear the voice, footstep, and so on. 10. Support 3 wired inputs (normally closed) and 16 wireless inputs can easily connect detectors or sensors like PIR Sensors, beams, gas/smoke detectors, panic buttons and so on. 11. Support 1 output for relay linkage, remote controlling appliance switch. 12. Siren port for shift between silence and siren. 13. Especially suitable for storeroom, garage and the places where have no telephone line. 14. Built-in800mA Ni-Hi battery, keep working if the power is failure and can recharge automatically. Code the detectors Power on the alarm panel, LED will keep green or flash green, you can press the reset key until the LED change from green to red. Then you can start to register them. For door sensor, just move the two parts of door sensor; it will beep or flash red to show successful. And for PIR Sensors, turn the switch to “on” and the system will beep or flash red to show successful and then turn it to “off” to avoid wrong alarm. For remote controllers, press any button on its panel and the system also beeps or flash red. For gas and smoke detectors, there is a black switch on the left side; you can press it to register it with base. Add more detectors You can add new sensors or detectors, such as wireless door sensors, PIR Sensors, gas and smoke detectors when you push the reset key until the LED change from green to red. You should trigger every sensor or detector, and the red LED will flash every time you register a sensor or detector with control unit successfully. After you finish it, you can push the reset key again or waiting for 20 seconds, it will retreat and automatically enter into working state. (With green LED) Cancel the lost detectors In case of the coded sensors or detectors are lost, you can cancel the coded information of these detectors so that they can not control your alarm system. Keep pressing the reset button, then power on the system. One beep sound or LED flashes, shows reset is successful. All registered detectors have been deleted from the unit. You can register them again with the above mentioned procedures. System reset will not change the SMS message. Standard pack components 1 alarm host, 2 remote controllers, 1 wireless door magnet detector, 1 wireless PIR detector, 1 alarm siren, 1 camera, 1 GSM antenna and 1 RF antenna, 1 12v DC adaptor, 1 user manual |
Do you want to show products of your own company? Join FREE now!
